Essay,
Pages 3 (594 words)
What is Detroit Diesel latest reprogramming and diagnostic software known as?
DDRS
What version of DDEC is used with post-2010 DD-Series engines?
DDEC 10
What is the primary function of the SRS?
signal engine position data
How many teeth does the TRS pulse wheel have on a typical DDEC system?
36
Which dash diagnostic light is used to flash active DDEC fault codes in systems without ProDriver?
SEL
What is the primary objective when the progressive shifting option is selected?
to improve fuel economy
When a DDEC engine programmed for ramp down as a failure strategy detects a low oil pressure condition, which dash light(s) will illuminate?
CEL and SEL
Technician A states that during an injector speed balance (ISB) test, an EHI displaying a positive value of plus 100 is likely to be defective.
Don’t waste time
Get Your Custom Essay on
“Chapter #43 – Detroit Diesel Electronic Control System”
Get High-quality Paper
helping students since 2016
Technician B states that an EHI displaying a negative value of minus 100 has no problems with fuel flow. Who is correct?
both A & B
Which was the first computer controlled, truck diesel engine to be manufactured in North America?
DDC Series 92 DDEC I
When an idle speed balance (ISB) test is run on a DD-Series engine and one injector displays a high negative value, which of the following is the likely cause?
injector is compensating for a high injection rate
What does the injector response time (IRT) allow DDEC electronics to do when managing pulse width in EUI-fueled engines such as the Series 60?
compensate for minor EUI circuit resistances
When an idle speed balance (ISB) test is run on a DD-Series engine with ACRS and one injector displays a high positve value, which of the following is the likely cause?
actuator malfunction
restricted nozzle
restricted high pressure line to the injector
Which sensor is used to signal engine position by camshaft location and confirm the crank position signal in a DDEC Series 60 engine?
synchronous reference sensor (SRS)
In current Detroit Diesel DDEC managed engines, which controller module has an address on the J1939 data bus?
common powertrain controller (CPC)
In current Detroit Diesel DDEC managed engines, which controller module is responsible for actuating fuel injection operations?
motor control module (MCM)
Which version of DDEC replaced the 2007 release of DDEC VI?
DDEC 10
What online service information software must be used when working with current Detroit Diesel engines?
power service literature (PSL)
What software is required to troubleshoot and reprogram current Detroit Diesel engines?
Detroit Diesel Reprogramming Station (DDRS)
Which of the following is the current DDEC term for the programming required to balance injector fuel flow variables?
IQCC
The CEL and SEL both illuminate while a DDEC managed engine is being operated on the highway.
Which of the following is also likely?
immediate engine power ramp down
In the DECVI management system, which module uses the MID 128 address on the chassis data bus?
CPC (common powertrain controller)
Which of the following versions of DDEC uses a two module system?
DDEC 10
The reason for programing DDEC ECM with IQCC is to:
enable the ECM to balance cylinder fueling
Where is the EDU located on a 2007 Series 60 engine?
within the DDEC ECM
Technician A states that one of the reasons DDEC VI electronics uses a two module system is that the electronic management system is also used on three engines with different fuel systems. Technician B states that in DDEC 10 the injector drivers are located in the MCM. Who is correct?
both A & B
What do DDEC electronics use as the for determining the rate of EHI fuel flow compesation required as a result of idle speed compesation (ISC) analysis?
crankshaft sector speed variations
Don’t waste time
Get Your Custom Essay on
“Chapter #43 – Detroit Diesel Electronic Control System”
Get High-quality Paper
helping students since 2016